Hello there,
I hope I get no dubble Post :-) If so "SORRY" (I am new in Using Mailling Lists)
today I Downloaded the latest Windows Version of udpcast from the Website. When I start the Programm on a PC with only one Network Interface it works fine (both sender and receiver).
But when I start it on the same PC (a VMware) with two Network Interfaces the Programm crashes immediately. I tryed to bind the Interface with: "--interface 192.168.1.2" (Yes the IP is the correct) but this also dosent work.
The only Message that appears is: "Udp-sender 2006-06-19" and for the receiver: "Udp-receiver 2006-03-25"
If the Windows Error Reporting Service is active it will send a Error Report to MS.
I hope this is only a small Error...
When it works it is a really cool Programm!
---------------------------------- Greetings from Germany
Bastian Stock
Bastian Stock wrote:
Hello there,
I hope I get no dubble Post :-) If so "SORRY" (I am new in Using Mailling Lists)
today I Downloaded the latest Windows Version of udpcast from the Website. When I start the Programm on a PC with only one Network Interface it works fine (both sender and receiver).
But when I start it on the same PC (a VMware) with two Network Interfaces the Programm crashes immediately. I tryed to bind the Interface with: "--interface 192.168.1.2" (Yes the IP is the correct) but this also dosent work.
The only Message that appears is: "Udp-sender 2006-06-19" and for the receiver: "Udp-receiver 2006-03-25"
If the Windows Error Reporting Service is active it will send a Error Report to MS.
I hope this is only a small Error...
When it works it is a really cool Programm!
Greetings from Germany
Bastian Stock
This is fixed in today's version (was due to a buffer overrun... Windows seems to need *huge* amounts of memory to store device information, and 2 ethernet cards were just too much... sigh!)
Regards,
Alain
-
Alain Knaff -
Bastian Stock