Donizeti - CTTSC wrote:
Good morning, I need to go SATA HD clone how to
proceed?
hug everyone.
Donizeti.
------------------------------------------------------------------------
_______________________________________________
Udpcast mailing list
Udpcast(a)udpcast.linux.lu
https://lll.lgl.lu/mailman/listinfo/udpcast
Well, you just boot up the udpcast CD or floppy, as you would for a PATA
disk, but near the end, you chose to load a "hard disk driver" module. By
default, it only proposes you modules corresponding to hardware (SATA
controllers) present in your machine, but for the case where it is wrong,
you can chose "other", and then you get the complete list.
If the correct module is chosen, you should see your SATA disks as
/dev/sda, /dev/sdb, etc. and its partitions as /dev/sda1 , /dev/sda2 or
similar.
Regards,
Alain