Well, the PC that had the 2.4.20-20.9 kernel got hosed and I had to
reinstall. It was a RH 9 install that had been updated.
I installed this time with a Mandrake 9.1 distro. I installed the
udpcast rpm and the kernel-udpcast rpm. I then downloaded the 2.4.21
kernel from ftp.kernel.org
and extracted it into /usr/src/linux-2.4.21/.
Then I copied the udpc-config.txt file into that dir and called it
.config. Then I edited the the Makefile and put in the -udpcast. I
then did a "make oldconfig" which ran fine. I also did the make dep &&
make bzImage && make modules && make modules_install and they all ran
fine. Then I ran ./makeImage -t net-mod.tar.gz -k
/usr/src/linux-2.4.21/arch/i386/boot/bzImage -f /dev/fd0 which seemed
to run ok. I tried to boot off of the floppy and I get:
Could not find ramdisk image: initrd
I've obviously missed something...what am I forgetting to do?
I have compiled the network card module, but haven't tried to build it
into the kernel yet. I'd like to get a working boot disk before I try
and make it hit the network.
>> alain.knaff(a)lll.lu 09/30/03 18:09 PM
On Tuesday 30 September 2003 23:58, Eric Becker wrote:
I have some hp pc's that I'm trying to
udpcast. They have broadcom
netxtreme network cards which don't seem to be supported by the
boot disk, nor by the net-mod.tar.gz secondary
I followed the directions here
custom boot disk by compiling my own kernel.
Before doing anything I edited the Makefile and changed the
"extra-version" parameter. I just deleted what was there and put in
"-udpcast". I do a cd /usr/src/linux/2.4.20-20.9. Then I copy the
udpc-config.txt file to this dir and name it .config. Next I do a
oldconfig" which runs fine and so does the
"make dep". However; when
do a "make bzImage" it runs for a while and
then it stops with errors
regarding devfs? What am I doing wrong?
Could you post the exact error messages?
Also, are you sure that this is an original kernel (as distributed by
). Indeed, the version number (2.4.20-20.9) strikes me
as somewhat odd...
I even tried to download the RPM with a pre-compiled
kernel and its
modules, but I'm unsure what do with it.
Just install it with rpm -i , and then run makeImage
Or, alternatively, use the online image generator at
Can someone please point me in
the right direction? All I need is a boot disk with the Broadcom
drivers that gets me udpcasting.
Not sure whether the necessary module is in the pre-compiled kernel.
If not, try getting kernel sources from ftp.kernel.org
, and compile